Updated November 2026
A battery for Bushnell rangefinder units is usually a single lithium coin or cylinder cell, and swapping it takes about two minutes with the right type on hand. This guide shows you how to identify the correct battery, replace it without damaging the seals, and check that the unit powers up properly afterward. Battery type varies by model, so confirm before you buy.
Identify the Correct Battery Type for Your Model
Bushnell rangefinders have used several battery formats across their product lines. Many older and mid-range golf and hunting models take a CR2 lithium cell, while some compact units use a CR2032 coin cell. Look for the battery designation printed on the compartment cover or in the owner’s manual. If the number is worn off, check the manual for the model you own, since a wrong size will either not fit or fail to make contact.
Shopping for one? See our guide: 5 Best Rangefinder Golfs with Slope Picks for Accurate Yardage (2026).
Do not substitute a battery of a different chemistry, such as an alkaline cell of similar size, unless the manual specifically allows it. Lithium cells hold voltage more steadily in cold weather, which matters for hunters who leave a unit in a cold pack or truck overnight.
Replace the Battery Step by Step
- Turn the rangefinder off and set it on a clean, dry surface.
- Locate the battery compartment cover. It is usually on the back or bottom and may be held by a small screw or a snap-in latch.
- Remove the cover slowly and note the battery’s orientation, positive side up or down, before you take it out.
- Insert the new battery with the same orientation. Avoid touching the contacts with bare fingers, since skin oil can reduce contact quality.
- Reseat the cover and tighten any screw until it is snug, not overtightened.
- Power the unit on and check the display. Confirm the battery indicator reads full and the unit responds to a button press.
Check the Seals and Contacts Before Closing Up
Rangefinders are used outdoors in rain, dust and cold, so the battery compartment seal matters. Wipe the compartment with a dry cloth before inserting the new cell. If you see corrosion, a white or greenish residue on the contacts, clean it gently with a cotton swab lightly dampened with isopropyl alcohol and let it dry fully. Replace any gasket that looks cracked or flattened, since a poor seal lets moisture reach the electronics.
Tips for Getting the Most From Each Battery
- Remove the battery during long storage periods to prevent slow leakage or corrosion.
- Keep a spare on hand for multi-day hunts or golf outings.
- Note the date you installed a new battery so you can track how long it lasts.
- Turn the unit off when not in use, since many models keep drawing a small current in standby.
Common Mistakes to Avoid
- Installing the battery backward, which can prevent the unit from powering on or damage the circuit.
- Using a battery size that is close but not correct, which may cause intermittent failures.
- Overtightening the compartment screw, which can crack the housing or strip the threads.
- Ignoring a weak battery warning until the unit fails at a critical moment.
Recommended Gear
A set of spare lithium cells in the correct size is the most useful thing to carry, so you are not stuck if the unit dies during a hunt. For reference, lithium cells such as the Energizer Ultimate Lithium CR2 are widely available in the CR2 format. View on Amazon
A small lens cloth and a bag of silica gel for your pack help keep the compartment dry and the optics clear between uses. View on Amazon
FAQ
What battery does a Bushnell rangefinder use?
It depends on the model. Many units use a CR2 lithium cell, while some compact models use a CR2032 coin cell. Check the compartment cover or the owner’s manual for the exact size.
Can I use an alkaline battery instead of lithium?
Only if the manual allows it. Lithium cells perform more consistently in cold conditions, which is why they are commonly specified for rangefinders.
How do I know when the battery needs replacing?
Watch for a low-battery indicator on the display, dim readings, or the unit shutting off unexpectedly. Replace the battery before a hunt rather than during one.
Conclusion
Confirm the correct battery size for your model, replace it with the same orientation, and check the seals while the compartment is open. A spare cell in your pack will save you from a dead rangefinder at the worst possible moment. For model-specific steps, consult your Bushnell manual or a qualified repair service.

